🖤 BF20 FOR 20% OFF, NO MINIMUM SPEND · BF30 FOR 30% OFF, MIN $200 SPEND 🖤

Audi TT Wiper Blade Sizes

This guide helps you find the right windscreen wiper blades for your Audi TT. It covers every generation of the TT, from the early cars through to the latest models. You do not need to know anything about wipers to use it. Just find your car's generation below and read off the driver side and passenger side sizes.

Wiper sizes differ between generations of the Audi TT. So the blades that fit one generation will not fit another. That is why it pays to check which generation your car is before you buy anything. Once you know your generation, matching each side is simple.

Start by working out which generation you have. Then look at the sizes listed for that generation. Fit the driver side blade and the passenger side blade to match. If you are unsure, the how to choose section below walks you through it step by step.

Audi TT wiper sizes for each generation

Audi TT 2014-2023 (FV)

Audi TT 2014-2023 (FV) wiper blades
Driver side24″600 mm
Passenger side20″500 mm

Push-button arm. The blade has a small push button that releases it from the end of your wiper arm.

Shop 2014-2023 (FV) wiper blades

For this generation, the driver side takes a 24 inch (600 mm) blade and the passenger side takes a 20 inch (500 mm) blade. Take a moment to compare the old blade with the new one before you fit it, so you are confident they match. Fit one side at a time and check the blade sits firmly before moving to the other side.

Audi TT 2006-2014 (8J)

Audi TT 2006-2014 (8J) wiper blades
Driver side22″550 mm
Passenger side20″500 mm

Fitting details for this arm are on the product page.

Shop 2006-2014 (8J) wiper blades

This generation uses a 22 inch (550 mm) blade on the driver side and a 20 inch (500 mm) blade on the passenger side. Before fitting, lay the new blade next to the old one to confirm the length looks right. Then ease the blade onto the arm and give it a gentle tug to make sure it is secure.

Audi TT 2003-2006 (8N Facelift)

Audi TT 2003-2006 (8N Facelift) wiper blades
Driver side21″525 mm
Passenger side21″525 mm

Fitting details for this arm are on the product page.

Shop 2003-2006 (8N Facelift) wiper blades

Here the driver side and the passenger side both take a 21 inch (525 mm) blade. It is worth checking both old blades against the new ones before you start. Fit each blade carefully and make sure it clicks or seats properly on the arm. Then lower the arm gently onto the glass rather than letting it snap down.

Audi TT 1998-2003 (8N)

Audi TT 1998-2003 (8N) wiper blades
Driver side21″525 mm
Passenger side21″525 mm

Hook-style arm. The end of your wiper arm is a curved hook, and the blade clips onto it.

Shop 1998-2003 (8N) wiper blades

For this generation, both the driver side and the passenger side take a 21 inch (525 mm) blade. Compare the new blades with the ones you are removing so you are sure of the match. When fitting, take your time on each side and confirm the blade is held firmly before you move on to the next one.

How to work out which Audi TT you have

To work out your generation, look at the year your Audi TT was built and compare it with the year ranges above. The generation code in brackets can also help you confirm it. If your car sits near a changeover year, double-check before ordering, because the sizes differ between generations.

Once you know your generation, note the driver side size and the passenger side size separately. They are not always the same, so match each side on its own. Buy one blade for the driver side and one for the passenger side to suit your car.

How to fit your new wiper blades

Hook-style arm

The end of your wiper arm is a curved hook, and the blade clips onto it.

  1. Lift the wiper arm away from the windscreen until it stays upright.
  2. Press the small release tab on the blade connector and slide the blade down and off the hook.
  3. Slide the new blade onto the hook until it clicks into place.
  4. Gently lower the arm back onto the glass.

Push-button arm

The blade has a small push button that releases it from the end of your wiper arm.

  1. Lift the wiper arm away from the windscreen until it stays upright.
  2. Press and hold the push button on the blade connector, then slide the blade off the end of the arm.
  3. Slide the new blade on until the button clicks back into place.
  4. Gently lower the arm back onto the glass.

When to replace your wiper blades

Worn wiper blades show themselves in several ways. You may see streaks of water left behind after each sweep. The glass may look smeared rather than clear. You might hear squeaking or juddering as the blades move across the screen.

Look closely at the rubber too. If it is split, cracked or coming away from the blade, it is time for a change. These signs mean the blade is no longer clearing the glass properly, and that can make it harder to see in the rain.

Good visibility matters for safe driving. Blades that streak or smear leave you guessing about the road ahead. Replacing worn blades is a small job that makes a real difference when the weather turns.

Looking after your wipers

Look after your wipers and they will look after you. Clean the glass regularly so the blades are not dragging over dirt. Wipe the rubber edge of each blade with a damp cloth now and then to remove grit and grime.

Sun and dust wear rubber down over time, so park in the shade where you can. When you clean the screen, lift the arms off the glass gently rather than forcing them. Keep your washer fluid topped up so you can clear the screen when you need to.

Wiper blade tips

  • Check your generation before you order any blades.
  • Match the driver side and passenger side sizes separately.
  • Compare the old blade with the new one before fitting.
  • Lower the wiper arm gently onto the glass.
  • Replace blades at the first sign of streaking or squeaking.
  • Keep the glass and the blade edges clean.

Frequently asked questions

How do I know which Audi TT generation I have?

Check the year your car was built and compare it with the year ranges in this guide. The generation code in brackets can help you confirm it. If your car is near a changeover year, double-check before you order.

Are the driver side and passenger side blades the same size?

Not always. Some generations use different sizes on each side, while others use the same size on both. Always check the driver side and passenger side sizes for your own generation before buying.

How often should I replace my wiper blades?

Replace them when you notice the signs of wear. Streaking, smearing, squeaking, juddering, or split and cracked rubber all mean it is time for a change. Do not wait for a rainy day to find out.

Why do the sizes differ between generations?

The sizes differ between generations of the Audi TT, so blades from one generation will not suit another. That is why it is important to confirm your generation first, then match the driver side and passenger side sizes listed for it.

Can I fit the blades myself?

Yes, fitting wiper blades is a simple job you can do at home. Fit one side at a time, check the blade sits firmly, and lower the arm gently onto the glass. Take care not to let the arm snap down.

What should I do if my new blades streak?

First clean the glass and the blade edges, as dirt often causes streaking. If the streaking continues, check that the blades are fitted correctly on each side. Worn or damaged rubber may also be the cause.

More Audi wiper blade sizes

If you can't find your car in the list, please scroll down to ensure you haven't missed it. If you're not 100% sure, select the option you think is closest. A photo of the car will be shown to help you confirm if it's the correct model. If you still can't find your car, please fill out the form below with your vehicle details and we'll respond shortly.

Enter valid email address!

Your name, Email Address and Correct Answer of QUIZ is required field!

Please do not use HTML tags.

Thank you for your inquiry. We will check and get back to you shortly.