Toyota Hilux Wiper Blade Sizes
This guide is for everyday Toyota Hilux owners who want to replace their windscreen wiper blades but are not sure where to start. It covers the wiper sizes for each generation of the Hilux Ute listed here. You do not need any technical knowledge. Just find your generation, note the driver side and passenger side sizes, and you are ready to shop.
Wiper sizes differ between generations of the Hilux. The sizes for the driver side and the passenger side are not the same across every generation, and in some generations the two sides are not even the same as each other. That is why it pays to check which generation you have before you buy anything.
To use this guide, first work out which generation matches your Hilux. Then read the driver side and passenger side sizes for that generation. Each generation also shows the wiper arm type, so you can see how the blade attaches. Take your time, check both sides, and you will get the right blades the first time.
The Hilux has changed over the years, and so have its wiper sizes. This guide walks you through each generation in turn. It also explains how to choose the right blades, when to replace worn ones, and how to look after your wipers so they last. Everything here is plain English, with no jargon and no guesswork.
Toyota Hilux wiper sizes for each generation
Toyota Hilux 2015-2026 Ute
Hook-style arm. The end of your wiper arm is a curved hook, and the blade clips onto it.
Shop 2015-2026 Ute wiper bladesFor the 2015-2026 Ute, the driver side takes a 22 inch (550 mm) blade and the passenger side takes a 16 inch (400 mm) blade. These two sides are different sizes, so match each blade to its own side when you buy. Before fitting, wipe the arm and the new blade clean so grit does not get trapped. Take a moment to check the blade sits firmly before you drive.
Toyota Hilux 2005-2015 Ute
Hook-style arm. The end of your wiper arm is a curved hook, and the blade clips onto it.
Shop 2005-2015 Ute wiper bladesThe 2005-2015 Ute uses a 21 inch (525 mm) blade on the driver side and an 18 inch (450 mm) blade on the passenger side. Because the two sides differ, keep each blade with the correct side as you unpack them. When fitting, lift the arm gently and let it rest back down slowly rather than snapping it onto the glass. A quick check that both blades are secure takes only a moment.
Toyota Hilux 1997-2005 Ute
Hook-style arm. The end of your wiper arm is a curved hook, and the blade clips onto it.
Shop 1997-2005 Ute wiper bladesOn the 1997-2005 Ute, both the driver side and the passenger side take a 17 inch (425 mm) blade. The two sides are the same size here, which makes buying simple. Even so, fit one side at a time so you do not mix up the arms. Give each new blade a gentle tug to confirm it is seated, then lower the arm carefully onto the glass.
Toyota Hilux 1989-1997 Ute
Hook-style arm. The end of your wiper arm is a curved hook, and the blade clips onto it.
Shop 1989-1997 Ute wiper bladesThe 1989-1997 Ute takes a 16 inch (400 mm) blade on the driver side and a 16 inch (400 mm) blade on the passenger side. Both sides match, so you can buy the same size for each. Before you fit them, clean the glass so the new rubber starts fresh. Check that each blade is clipped on properly, and lower the arm by hand rather than letting it drop.
How to work out which Toyota Hilux you have
Start by working out which generation your Hilux belongs to. The years for each generation are listed above, so compare them with your vehicle. If you are unsure, check your paperwork or look for the details that identify your model year. Getting the generation right is the first step, because the sizes change from one generation to the next.
Once you know your generation, note the driver side size and the passenger side size separately. Some generations use different sizes on each side, so do not assume one blade fits both. Match each side to the list, buy the correct blade for each, and keep them labelled as you fit them. That way you avoid a wiper that is too long or too short.
How to fit your new wiper blades
Hook-style arm
The end of your wiper arm is a curved hook, and the blade clips onto it.
- Lift the wiper arm away from the windscreen until it stays upright.
- Press the small release tab on the blade connector and slide the blade down and off the hook.
- Slide the new blade onto the hook until it clicks into place.
- Gently lower the arm back onto the glass.
When to replace your wiper blades
Worn wiper blades show themselves in simple ways. You may see streaks of water left behind after each sweep. The glass may look smeared rather than clear. You might hear squeaking or juddering as the blades move. The rubber itself can look split, cracked or ragged along the edge. Any of these signs means it is time for a new set.
Poor visibility in rain is a safety issue. If your blades cannot clear the glass properly, you see less of the road, other cars and pedestrians. Streaks and smears can hide hazards, especially in heavy rain or at night. Replacing worn blades is a small job that makes a real difference to how well you can see.
Do not wait for a storm to notice. Check your blades from time to time and look at the rubber edge. If it looks worn or the glass never comes clean, fit new blades. Keeping your wipers in good order helps you drive with confidence in wet weather.
Looking after your wipers
Look after your wipers and they will look after you. Clean the glass regularly so grit and grime do not wear the rubber. Wipe the blade edges with a damp cloth now and then to remove dust. Sun and dust both wear rubber over time, so a little care goes a long way.
When you wash the car, lift the arms off the glass to clean underneath, then lower them gently by hand. Never let an arm snap back onto the glass. Check your washer fluid too, so you can clear the screen when you need to. These small habits keep your wipers working well.
Wiper blade tips
- Check which generation your Hilux is before buying blades.
- Match each blade to the driver side or passenger side as listed.
- Clean the glass and the blade edges regularly.
- Lift the arms by hand and lower them gently.
- Replace blades at the first sign of streaking or squeaking.
- Keep your washer fluid topped up for clearer vision.
Frequently asked questions
How do I know which generation my Hilux is?
Compare the years listed for each generation with your vehicle. Your paperwork or model year details will help you confirm it. Once you have the right generation, the driver side and passenger side sizes are easy to find.
Are the driver side and passenger side always the same size?
No. Some generations use different sizes on each side, while others use the same size for both. Always check the driver side and passenger side separately so you buy the correct blade for each.
How do I fit the blade to the arm?
The arm type is shown for each generation. Follow that fitting method, lift the arm gently, and clip the new blade into place. Give it a gentle tug to check it is secure before lowering the arm.
When should I replace my wiper blades?
Replace them when you see streaking, smearing, squeaking or juddering, or when the rubber looks split or cracked. Poor visibility in rain is a clear sign that new blades are needed.
Can I replace just one blade?
Yes, you can replace one blade at a time. However, if one blade is worn, the other is often worn too. Replacing both together keeps your view clear and saves you doing the job twice.
How can I make my wipers last longer?
Clean the glass and the blade edges regularly. Park out of harsh sun where you can. Lift the arms by hand when cleaning and lower them gently. Keep your washer fluid topped up so you can clear the screen.
