🖤 BF20 FOR 20% OFF, NO MINIMUM SPEND · BF30 FOR 30% OFF, MIN $200 SPEND 🖤

Chevrolet Camaro Wiper Blade Sizes

This guide helps you pick the right windscreen wiper blades for your Chevrolet Camaro. It covers the two generations listed here and gives you the driver side and passenger side sizes for each one. You do not need to know anything about wipers to use it. Just find your car's generation, note the sizes, and you are ready to shop.

The sizes differ between the generations. That means a blade that fits one Camaro generation will not necessarily fit another. Always match the blades to your own car rather than assuming they are the same across the range.

Start by working out which generation you have, using the year range below. Then read the sizes for the driver side and the passenger side. Check the wiper arm type shown for your generation so you know how the blade attaches. When you are ready, match each side to its own size and fit the blades carefully.

The two generations in this guide are the 2018-2025 (6th Gen) and the 2010-2015 (5th Gen). Each has its own driver side and passenger side sizes. Take a moment to confirm your generation before you order, because the sizes are not shared between them.

Chevrolet Camaro wiper sizes for each generation

Chevrolet Camaro 2018-2025 (6th Gen)

Chevrolet Camaro 2018-2025 (6th Gen) wiper blades
Driver side22″550 mm
Passenger side20″500 mm

Hook-style arm. Your wiper arm uses a hook-type connector, and the blade supplied is made for it.

Shop 2018-2025 (6th Gen) wiper blades

For the 2018-2025 (6th Gen) Camaro, the driver side takes a 22 inch (550 mm) blade and the passenger side takes a 20 inch (500 mm) blade. Keep each blade with its own side when you fit them, since the two lengths are different. Before fitting, lift the arm gently away from the glass so you have room to work. Check that the new blade sits firmly and lies flat against the windscreen before you lower the arm back down.

Chevrolet Camaro 2010-2015 (5th Gen)

Chevrolet Camaro 2010-2015 (5th Gen) wiper blades
Driver side24″600 mm
Passenger side21″525 mm

Hook-style arm. Your wiper arm uses a hook-type connector, and the blade supplied is made for it.

Shop 2010-2015 (5th Gen) wiper blades

For the 2010-2015 (5th Gen) Camaro, the driver side uses a 24 inch (600 mm) blade and the passenger side uses a 21 inch (525 mm) blade. Fit the driver side blade first, then the passenger side, so you do not mix up the two lengths. Take care when lifting the arm so it does not spring back onto the glass. Once both blades are on, run the wipers briefly and check they sweep cleanly without catching.

How to work out which Chevrolet Camaro you have

To work out which generation you have, check the year your Camaro was built. The 2018-2025 (6th Gen) and the 2010-2015 (5th Gen) are listed separately here. If your car falls in one of these ranges, use the sizes for that generation. If you are unsure, check your vehicle paperwork or the plate on the car before ordering.

Once you know your generation, note the driver side size and the passenger side size. They are different from each other, so buy one blade for each side in the correct length. Match each blade to its own side when fitting. Do not swap them, and do not assume one size fits both sides.

How to fit your new wiper blades

Hook-style arm

The end of your wiper arm is a curved hook, and the blade clips onto it.

  1. Lift the wiper arm away from the windscreen until it stays upright.
  2. Press the small release tab on the blade connector and slide the blade down and off the hook.
  3. Slide the new blade onto the hook until it clicks into place.
  4. Gently lower the arm back onto the glass.

When to replace your wiper blades

Worn wiper blades show up in several ways. You may see streaks left across the glass, or smears that make it harder to see. Some blades squeak or judder as they move. Others leave patches of water behind. Any of these signs means it is time to think about new blades.

Look closely at the rubber too. If it is split, cracked, or coming away from the blade, it will not clear the glass properly. A blade in this state can scratch or leave you with poor visibility in rain. Replacing worn blades is a simple job that makes a real difference.

Good visibility matters for safe driving. Rain, spray, and grime all reduce what you can see, and tired blades make it worse. Fresh blades clear the glass more evenly, so you can see the road ahead. Do not wait for a storm to notice the problem. Check your blades regularly and replace them when they stop doing their job.

Looking after your wipers

Look after your wipers and they will last longer. Clean the glass regularly so the blades are not dragging over grit and dirt. Wipe the rubber edge of each blade with a damp cloth now and then to remove grime. Sun and dust wear rubber down over time, so park in shade where you can and keep the screen clean.

When you clean the glass, lift the arms off the screen so you can reach the full blade. Do not let an arm snap back down onto the glass. Check your washer fluid too, so you can clear the screen when you need to. A little routine care keeps your wipers working well.

Wiper blade tips

  • Check your generation before ordering any blades.
  • Buy one blade for the driver side and one for the passenger side.
  • Match each blade to its own side when fitting.
  • Lift the arm gently and never let it snap back onto the glass.
  • Clean the glass and the blade edges regularly.
  • Replace blades when they streak, squeak, or smear.

Frequently asked questions

How do I know which generation my Camaro is?

Check the year your car was built and compare it with the ranges in this guide. The 2018-2025 (6th Gen) and the 2010-2015 (5th Gen) are listed separately. Use the sizes for the generation your car falls into.

Are the driver and passenger blades the same size?

No. Each generation has its own driver side and passenger side sizes, and they are different from each other. Buy the correct length for each side and keep them matched when you fit them.

How does the blade attach to the arm?

For both generations listed here, the arm is a hook-style arm. The end of your wiper arm is a curved hook, and the blade clips onto it. Check this against your own car before fitting.

How often should I replace my wiper blades?

There is no fixed number here. Replace them when you notice streaks, smears, squeaks, judder, or split and cracked rubber. If visibility in rain is poor, new blades are a sensible step.

Can I fit the blades myself?

Yes. Lift the arm gently off the glass, clip the new blade into place, and lower the arm carefully. Fit the driver side and passenger side one at a time so you do not mix up the lengths.

What should I check after fitting new blades?

Run the wipers briefly and watch how they sweep. Check that each blade lies flat, clears the glass evenly, and does not catch or judder. If something looks wrong, stop and refit the blade.

More Chevrolet wiper blade sizes

If you can't find your car in the list, please scroll down to ensure you haven't missed it. If you're not 100% sure, select the option you think is closest. A photo of the car will be shown to help you confirm if it's the correct model. If you still can't find your car, please fill out the form below with your vehicle details and we'll respond shortly.

Enter valid email address!

Your name, Email Address and Correct Answer of QUIZ is required field!

Please do not use HTML tags.

Thank you for your inquiry. We will check and get back to you shortly.