BMW 1 Series Wiper Blade Sizes
This guide helps you find the right windscreen wiper blades for your BMW 1 Series. It covers every generation listed here, from the early hatch through to the latest model. You do not need to know anything about wipers to use it. Just match your car to the right generation and note the sizes for each side.
Sizes differ between generations, so it pays to check which one you have before ordering. Some generations share the same sizes, while others are quite different. Getting the match right means the blades will fit your car properly and clear your windscreen well.
Start by working out which generation matches your car. Then read the sizes for the driver side and passenger side, and the rear where one is listed. Take a moment to check your current blades and arms before you buy. If anything looks unclear, compare your car carefully against the years shown.
Each section below gives the sizes for one generation. Where a generation has a rear wiper, the rear size is included too. Read the section for your car, then use the general advice on choosing, replacing and caring for your blades to get the most from them.
BMW 1 Series wiper sizes for each generation
BMW 1 Series 2024-2026 (F70) Hatch
Hatch.png)
Push-button arm. The blade has a small push button that releases it from the end of your wiper arm.
Shop 2024-2026 (F70) Hatch wiper bladesFor this generation, the driver side takes a 26 inch (650 mm) blade and the passenger side takes a 17 inch (425 mm) blade. There is also a rear wiper, which takes a 14 inch (350 mm) blade. Before fitting, check that each new blade clicks securely onto the arm and sits flat against the glass. A quick test run with the washers will show you whether everything is seated properly.
BMW 1 Series 2020-2024 (F40) Hatch
Hatch.png)
Fitting details for this arm are on the product page.
Shop 2020-2024 (F40) Hatch wiper bladesThis generation uses a 26 inch (650 mm) blade on the driver side and a 17 inch (425 mm) blade on the passenger side. A rear wiper is fitted as well, and it takes a 14 inch (350 mm) blade. When you change the blades, take care to line up each one with its own arm so the driver and passenger sides do not get mixed up. Wipe the arm ends clean before you push the new blades on.
BMW 1 Series 2011-2019 (F20) Hatch

Fitting details for this arm are on the product page.
Shop 2011-2019 (F20) Hatch wiper bladesHere the driver side needs a 22 inch (550 mm) blade and the passenger side needs a 19 inch (475 mm) blade. This generation also has a rear wiper, which uses a 12 inch (300 mm) blade. It is worth checking the old blades against the new ones side by side before fitting, so you can see they are the same length. Then press each blade firmly onto its arm until it feels secure.
BMW 1 Series 2008-2013 (E88) Convertible

Fitting details for this arm are on the product page.
Shop 2008-2013 (E88) Convertible wiper bladesFor this convertible, both the driver side and the passenger side take a 20 inch (500 mm) blade. There is no rear wiper listed for this generation. When fitting, lift each arm away from the glass so you have room to work, and take care not to let an arm snap back down onto the windscreen. Check that both blades rest evenly along the glass once they are on.
BMW 1 Series 2008-2013 (E82) Coupe
Coupe.png)
Fitting details for this arm are on the product page.
Shop 2008-2013 (E82) Coupe wiper bladesThis coupe uses a 20 inch (500 mm) blade on the driver side and a 20 inch (500 mm) blade on the passenger side. No rear wiper is listed for this generation. Before you fit the new blades, look over the arms for any bends or damage, and clean the ends so the blades seat well. After fitting, run the wipers once and check the sweep is smooth and even.
BMW 1 Series 2004-2011 (E87) Hatch

Fitting details for this arm are on the product page.
Shop 2004-2011 (E87) Hatch wiper bladesOn this generation, the driver side takes a 20 inch (500 mm) blade and the passenger side takes a 20 inch (500 mm) blade. A rear wiper is also fitted, and it takes an 11 inch (275 mm) blade. Take a moment to check each blade is the correct length for its position before fitting, then press it home until it holds firmly. A short test with the washers confirms a good fit.
How to work out which BMW 1 Series you have
To work out which generation you have, start with the year your car was built and compare it with the years listed for each generation. The letter and number code in brackets, such as F70 or E87, is a useful extra clue. If your car sits near a changeover year, check the code as well as the year so you pick the right section.
Once you know your generation, note the size for the driver side and the size for the passenger side separately. They are often different, so match each side on its own rather than assuming one size fits both. Where a rear wiper is listed, note that size too. Buying the correct size for each position keeps your view clear and helps the blades last.
How to fit your new wiper blades
Push-button arm
The blade has a small push button that releases it from the end of your wiper arm.
- Lift the wiper arm away from the windscreen until it stays upright.
- Press and hold the push button on the blade connector, then slide the blade off the end of the arm.
- Slide the new blade on until the button clicks back into place.
- Gently lower the arm back onto the glass.
When to replace your wiper blades
Worn wiper blades show themselves in several ways. You may see streaks of water left behind after each sweep, or a smeary film that makes the glass harder to see through. Some blades squeak or judder across the windscreen. Others leave patches untouched. Any of these signs means it is time to think about new blades.
It also helps to look closely at the rubber itself. Split, cracked or hardened rubber cannot clear the glass properly, even if the blade still moves. If the edge looks ragged or feels stiff, replace it. Checking the blades now and then, rather than waiting for a stormy day, saves you trouble later.
Clear vision matters for safe driving. Rain, spray and grime all reduce what you can see, and tired blades make it worse. Good blades clear the glass quickly and quietly, so you can focus on the road. Replacing worn blades is a small job that makes a real difference to your safety.
Looking after your wipers
Look after your wipers and they will look after you. Clean the windscreen regularly, as dust and grime wear the rubber down faster. Wipe the blade edges with a damp cloth now and then to remove grit. Strong sun and dusty conditions also take their toll on rubber over time, so a little cleaning goes a long way.
When you wash the car, lift the arms off the glass to clean underneath, but take care not to let them snap back down. Check your washer fluid regularly and top it up so you can clear the screen when you need to. A quick glance at the blades each month helps you spot wear early.
Wiper blade tips
- Check your generation before ordering any blades.
- Match the driver side and passenger side sizes separately.
- Clean the glass and blade edges regularly.
- Replace blades at the first sign of streaking or squeaking.
- Lift the arms carefully and never let them snap back.
- Keep your washer fluid topped up for clearer vision.
Frequently asked questions
How do I know which generation my 1 Series is?
Compare the year your car was built with the years listed for each generation. The code in brackets, such as F70 or E87, is a helpful extra clue. If your car is near a changeover year, check the code as well as the year.
Are the driver and passenger blades the same size?
Not always. Some generations use different sizes on each side, while others use the same size for both. Always check the driver side and passenger side sizes separately for your generation before ordering.
Does my car have a rear wiper?
Some generations in this guide list a rear wiper and some do not. Check the section for your generation. If a rear size is shown, your car has a rear wiper and you can match that size too.
How often should I replace my wiper blades?
There is no fixed rule, so watch for the signs instead. Streaking, smearing, squeaking, judder or split rubber all mean it is time for new blades. Replacing them when these appear keeps your view clear in the rain.
Can I fit the blades myself?
Yes, fitting blades is a simple job. Lift the arm off the glass, release the old blade, and press the new one on until it holds firmly. Take care not to let the arm snap back onto the windscreen while you work.
Why do my new blades squeak?
Squeaking can come from a dirty windscreen or gritty blade edges. Clean the glass and wipe the blade edges with a damp cloth. If the noise continues, check that each blade is fitted securely and sits flat against the glass.
More BMW wiper blade sizes
- BMW 2 Series Wiper Blade Sizes
- BMW 3 Series Wiper Blade Sizes
- BMW 6 Series Wiper Blade Sizes
- BMW 7 Series Wiper Blade Sizes
- BMW 8 Series Wiper Blade Sizes
- BMW M2 Wiper Blade Sizes
- BMW M3 Wiper Blade Sizes
- BMW M4 Wiper Blade Sizes
- BMW M6 Wiper Blade Sizes
- BMW M8 Wiper Blade Sizes
- BMW X1 Wiper Blade Sizes
- BMW X2 Wiper Blade Sizes